Setting up Sun/Linux machines

Installing Linux Machines

Red Hat Enterprise Linux (RHEL) machines are installed over the network, much like a Windows RIS, but require less user interaction. You will need a machine that is registered on the campus network, an active network port, and a RHEL boot cd. Since the install is done over the campus network, you can install a RHEL machine from any location, but in the Wolftech workroom you can use the bays on the two right-hand tables. There are two network switches to connect to, one for VLAN 436 (Faculty/Staff), and one for VLAN 437 (Research).

Two things to note: first, make sure you have the proper boot CD, as there are separate CDs for 32 and 64bit, and the version of the boot CD must match the version that is being installed. If you need a new boot CD, you can download the ISO files from [1].

Second, the RHEL install will work with any network card except the Marvell Yukon onboard NICs found in the JWBs. For those machines you will need to install a PCI network card (preferably 3COM) for the install to work. Once the installation is finished, you can switch back to the onboard NIC.

Set up RHEL install

• Register machine on campus network.

• Email Micah and ask him to setup the machine for a RHEL install. Let him know whether it is 32 or 64bit RHEL, and give him the FQDN of the machine. If you are going to do the installation outside of the workroom, let him know which building you will be installing it in.

Start the install

• After Micah has done the setup, set up the machine and boot it to the RHEL boot CD. For Dells, IBMs, and HP/Compaqs, hit F12 to reach the boot menu, for JWBs, hit F8.

• The machine will run the boot agent on the CD, connect to the network by DHCP, and download the image files for the installation. If the installation stops at this point it's usually one of two reasons. Either it cannot get a network connection (bad card, bad cable